







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Balch Springs, TX: What It Costs and How Long It Takes
Concrete driveways & concrete work in Balch Springs, TX typically run $4,500 – $12,000 for a new driveway pour, with most single-car and standard two-car jobs landing in the $6,000 – $9,000 range. A straight replacement of an existing slab runs $5,000 – $14,000 once demolition and haul-off are included. Plan on 3 – 5 days from demo to the day you can drive on it, and call (833) 954-4985 for a free on-site estimate before you commit to a number.
How the work actually runs, day by day

Concrete is unforgiving of shortcuts, and the schedule below is what a properly sequenced job looks like when we’re working a Balch Springs driveway.
Day 1: Demo, layout and subsurface check
We pull the old slab, haul it off, and cut back any tree roots that have lifted the existing pour. That first day also settles the biggest unknown: what’s under the concrete. On Balch Springs’ older ranch lots, we sometimes find a buried layer of caliche, an old patio slab poured on top of the original, or a utility line that isn’t where the city drawings say. If the subgrade is soft, we over-excavate and bring in compacted fill rather than pouring over a sponge.
Day 2: Forming and grading
We set forms to the final grade and establish the slope away from the house. Drainage is the decision you’ll make with us here: where the water goes matters more in a clay-soil town than almost anywhere. You’ll confirm the width, the apron flare at the street, and whether you want a control-joint pattern that reads clean or a scored grid. This is also when we confirm whether any sprinkler lines, gas stubs or low-voltage runs need to be relocated before the pour.
Day 3: Base prep, rebar and inspection
Compacted base goes in, then rebar or welded wire mesh set on chairs so it sits in the middle of the slab rather than on the dirt. If your project requires a permit and inspection, we schedule it at this stage before any concrete shows up. Homes in flood-adjacent parts of town often need the finished elevation confirmed here too, which is why we don’t skip this step.
Day 4: The pour
One crew, one continuous pour, no cold joints in the middle of a driveway. We place, screed, float and finish on site. You’ll pick your finish before this day – broom for traction, a light exposed aggregate, or a saw-cut border pattern. Broom finish is the default for a reason: it’s the safest under wet tires and the least fussy to maintain.
Day 4 – 5 and after: Curing and joints
We cut control joints within 24 hours so the concrete cracks where we tell it to, not where it wants to. You can walk on it in about a day and drive on it in roughly 7 days, though full cure takes about 28 days before you should park anything heavy like a loaded truck or trailer. We’ll give you the exact back-off window in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Choosing your concrete spec: what actually changes the price
Concrete isn’t one product. The spec you pick is the single biggest lever on both cost and how the slab behaves ten summers from now.
- Standard 4-inch slab with mesh – the budget path. Fine for foot traffic, light cars, and a straightforward single-car apron. It won’t hold up to a heavy truck or poorly drained clay soil without cracking.
- 5 – 6-inch slab with rebar – the right call for most Balch Springs driveways. The added thickness and steel cost a bit more up front and pay for themselves when the Blackland clay moves.
- Fiber-reinforced mix – a mid-grade option that reduces surface micro-cracking and is often paired with rebar on larger pours. It’s not a replacement for steel in a driveway.
- Broom finish vs. exposed aggregate – broom is standard and slip-resistant; exposed aggregate gives more texture and a warmer look but costs more and holds dirt in shaded spots.
- Color and stamping – integral color or a stamped border adds visual interest and cost. If you want the full decorative route, that’s better handled as a Driveway & Pavers in Balch Springs conversation, since pavers and stamped overlays open up options a plain pour doesn’t.
- Drainage extras – a channel drain, a French drain at the low corner, or a swale regrade. On tight lots near the creek bottomlands, these aren’t cosmetic; they’re what keeps water out of the garage.
What Concrete Driveways & Concrete Work costs in Balch Springs, TX

Here’s the line-item view of what you’re actually paying for.
| Line item | Typical range |
|---|---|
| Concrete driveway installation (new pour) | $4,500 – $12,000 |
| Driveway replacement (demo + new pour) | $5,000 – $14,000 |
| Sealing (after cure) | $250 – $700 |
Five variables push a job toward the low or high end here: square footage and thickness (a 400 sq ft single-car apron vs. a 900 sq ft two-car drive with a turnaround); existing slab condition (a clean demo is cheap, a slab poured over an old one is not); drainage and grading work (regrades, channel drains, retaining edges); the finish spec (broom vs. colored or exposed); and permit and floodplain review where the site warrants it. A written estimate from us spells out demo, haul-off, base material, steel, thickness, finish, joints, and disposal. What it won’t include unless we say so: relocating irrigation or utility lines, and any decorative stamping or staining.
See the difference
Before
After
Before
After
Before
AfterWhy Balch Springs lots test a concrete job differently
Balch Springs is a built-out inner-ring suburb, not a subdivision still going up, so most of the work here is replacing something that’s already failed. Much of the housing in ZIP 75180 is modest mid-century ranch stock from the 1950s through the 1970s, and a lot of those original driveways are 50-plus years old, poured thin, and cracked along the same lines the soil moves under. The Blackland Prairie clay underneath is the culprit: it swells through the wet spring and shrinks hard in a dry North Texas summer, and a 4-inch slab with no steel doesn’t survive that cycle for long. That’s why we almost never quote mesh-only on a Balch Springs replacement. Add the flood-sensitive ground near the South Mesquite Creek and Trinity River bottomlands and you get sites where finished elevation and drainage direction matter as much as the concrete itself. Permitting here runs more like a small town than Dallas, and we handle it. If the project grows beyond the driveway into a structure, homeowners often pair this with ADU Site Prep & Utilities in Balch Springs and the flatwork gets scheduled around it.
Serving Balch Springs, TX – Our Local Coverage Area
We serve Balch Springs and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Concrete Driveways & Concrete Work in Balch Springs

Most jobs run 3 – 5 days from demo to final cleanup, then roughly 7 days before you drive on it and about 28 days for full cure. Tight lots and floodplain review can add a few days to the front end.
It depends on the scope and the site. A straight like-for-like replacement often doesn’t, but any change in grade, drainage, or elevation near flood-sensitive ground usually does, and we confirm with the city before we pour. We handle the paperwork and the inspection scheduling.
In most cases, yes. We check for irrigation, gas stubs and low-voltage runs during day-1 demo, and we can route around established trees and beds. If a line is directly in the pour path, relocating it is a separate line item we quote up front.
New concrete driveway installation runs $4,500 – $12,000; a full replacement runs $5,000 – $14,000; sealing after cure adds $250 – $700. Thickness, drainage and finish drive the spread. Call (833) 954-4985 for an exact quote – estimates are free.
Every project is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers workmanship, not damage from tree roots or vehicles you’ve added after the fact.
Get a free estimate on your Balch Springs driveway
We’ll come out, measure the existing slab, check the grade and drainage, and put a written line-item estimate in your hands at no charge. No change orders once work starts – the number you see is the number you pay, and 0% financing for 18 months is available. Call (833) 954-4985 and a live person picks up, day or night. If your project is part of a bigger scope, our Driveway & Pavers service covers the rest, and you can see the full Balch Springs service area. Homeowners often pair this with Door Installation in Balch Springs.
Written by the team at Groundwork Construction Co.












