







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Allen, TX: What It Takes and What It Costs
Asphalt driveway paving in Allen, TX runs $3,500 to $9,000 for a typical two-car drive, and a full resurface (mill-and-overlay or a fresh wearing course over sound base) lands $5,000 to $14,000 as a replacement figure. Most jobs finish in two to four days, weather permitting. You’ll know your exact number before we break ground: call (833) 954-4985 to schedule a free on-site estimate.
Here’s the short version of what most Allen homeowners are actually dealing with. Their asphalt was laid when the subdivision went in, it’s been sealed a couple of times, and now it’s showing the same three problems: edge raveling where the drive meets the lawn, alligator cracking in the wheel paths, and a slow dip near the apron where the black clay underneath has moved. The question isn’t really “paving or not.” It’s whether the base is still worth saving, and that’s a $3,000 swing in either direction.
How Groundwork Handles Asphalt Driveways & Resurfacing Here

A proper asphalt job is five stages, and each one has a decision point that’s yours to make. Skip any of them and the pavement fails early.
Stage 1: Evaluation and base testing (60 – 90 minutes)
We probe the existing base, check drainage slope, and look at what’s under the apron. On Allen’s black clay, the subgrade is the whole ballgame. You decide here between a resurface over sound base or a full remove-and-replace, and we give you both numbers in writing so the choice is yours, not ours.
Stage 2: Demo and grading (day 1)
If we’re replacing, the old asphalt comes up and goes out the same day. We re-grade for positive drainage away from the foundation and garage slab, which matters more than people think on small Allen lots where the drive pitches toward the house. You approve the finished grade before gravel goes down.
Stage 3: Base prep and compaction (day 1 into day 2)
We lay crushed stone base in lifts and compact each lift. This stage is invisible once the asphalt is down, so it’s the one we don’t rush. You’ll see the compacted base before paving starts and can walk it with us.
Stage 4: Paving and rolling (day 2 or 3)
Hot-mix asphalt goes down at the right temperature, gets rolled while it’s still workable, and the edges get feathered or edged cleanly against the lawn and apron. This is the day you don’t drive on it. We’ll tell you the exact window.
Stage 5: Cure, seal, and final walkthrough (day 3 to week 2)
Light foot traffic after 24 hours, vehicles after 48 to 72 depending on temperature. Sealer, if you’re doing it, waits until the asphalt has fully cured, not day three. We do the final walkthrough together and put the 730-Day Done Right Promise on record in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make on an Allen Asphalt Drive
- Resurface vs. full replacement. A resurface costs less and is faster, but only works if the base is solid and the cracking hasn’t worked its way through. If the base is failing, a resurface just inherits the problem.
- Mix grade. Standard binder and wearing courses are fine for most residential drives. Higher-traffic or steep drives benefit from a heavier wearing course. Ask and we’ll quote both.
- Edge treatment. Feathered edges, concrete curb, or stone edging. Concrete curb holds up longest where the drive meets grass; it costs more but stops the raveling you’re probably already seeing.
- Drainage correction. A swale, a trench drain at the apron, or re-grading. Not glamorous, but on Allen’s clay this is the difference between a drive that lasts 20 years and one that dips in five.
- Sealer timing. Fresh asphalt should cure before sealing. It’s worth knowing so nobody sells you a coat too early.
Brand names rarely matter for asphalt, but when your drive ties into a larger hardscape or a Hardie-sided facade, we’re happy to coordinate the finished look.
What Asphalt Driveways & Resurfacing Costs in Allen, TX

Paving a new asphalt drive: $3,500 to $9,000. Full replacement on a failing base: $5,000 to $14,000. Resurfacing over sound base runs lower than that, and sealing alone is a small line item. Here’s what moves the number:
- Square footage. The biggest driver. A single-car drive sits at the low end; a wide three-car or a long drive to a detached garage pushes the high end.
- Existing condition. Alligator cracking and dips mean base failure, which means demo and rebuild, not a resurface.
- Access and slope. Tight lots and steep drives take longer and more handwork.
- Drainage work. Trench drains or regrading add cost but prevent a repeat problem.
- Edging and finishing. Concrete curbs, decorative borders, and tie-ins to walkways or patios add line items.
Written estimates from us include demo, haul-off, base, asphalt, compaction, and cleanup. They typically exclude any concrete apron replacement, landscape repair, or utility relocation if the drive crosses a line. Ask and we’ll tell you what’s in and what’s out before you sign.
See the difference
Before
After
Before
After
Before
AfterWhat Allen Driveways Specifically Deal With
Allen built out almost entirely after 1990, so the asphalt we replace here is 1990s-to-2020s subdivision stock, not old pavement. That means the problems are predictable: the original base was laid for the builder, the clay underneath has shifted through a couple of decades of North Texas wet-dry cycles, and the drive is now showing edge raveling and mid-slab cracking. The 75002 corridor along US 75 has lots of the earlier subdivision drives that are ready for replacement. In 75013, the newer custom homes often sit on tighter lots where the drive pitches toward the slab, so drainage correction matters. We cover the whole city, and if you’re outside our normal route, our Allen service page has the full picture.
One local reality: on the small lots typical of Allen’s 1990s subdivisions, drives often butt against the garage, a fence line, and the neighbor’s property line all within a few feet. That means drainage and edge design need to be settled before anything is laid. It also means when you’re pairing a new drive with a boundary repair, homeowners often pair this with Chain Link Fence in Allen or, if you’re planning a detached structure on the back lot, ADU Site Prep & Utilities in Allen. Both get coordinated into the same site plan.
If you want to see how asphalt fits into a bigger hardscape picture, look at our Driveway & Pavers service or the full scope on our Driveway & Pavers in Allen page.
Serving Allen, TX – Our Local Coverage Area
We serve Allen and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Allen

Most residential drives in Allen are done in two to four days from demo to finished asphalt, weather permitting. Curing takes longer: foot traffic after 24 hours, vehicles after 48 to 72. Call (833) 954-4985 for a schedule that fits your timeline.
Repaving or resurfacing an existing drive usually doesn’t need a permit, but a new drive, a widened drive, or anything that touches the right-of-way can require one. Allen’s HOA architectural review often comes before the city permit, so we advise getting the HOA approval lined up early. We can walk you through the sequencing.
A resurface works only if the base is sound and the cracking hasn’t broken through. Alligator cracking or dips usually mean base failure, which needs full removal and rebuild. We test the base during the estimate and quote both options.
Resurfacing over a sound base typically runs less than a full replacement, which is $5,000 to $14,000; a new asphalt drive is $3,500 to $9,000. Actual cost depends on size, base condition, and drainage. Call (833) 954-4985 for a free written estimate.
Every asphalt drive we install is backed by our 730-Day Done Right Promise – one of the longest workmanship guarantees in residential construction. If something isn’t right, we make it right. Call (833) 954-4985 to get started.
Get a Free Asphalt Driveway Estimate in Allen
We’ll come out, probe the base, talk drainage and edging, and hand you a written line-item estimate with no surprises. You’ll know up front whether a resurface will hold or a full replacement is the honest call. Call (833) 954-4985 for a free on-site estimate. A live person answers 24/7, and estimates are always free.
Written by the team at Groundwork Construction Co.












