







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Sachse, TX: What It Takes and What It Costs
Concrete driveways and concrete work in Sachse, TX run $4,500 – $12,000 for a full driveway installation, and most residential pours are finished in three to five working days once the subgrade is ready. A slab replacement typically lands at $5,000 – $14,000. The number that matters most is how the clay under the slab is handled before a single yard of concrete shows up. Call (833) 954-4985 for a free on-site estimate.
How We Build a Concrete Driveway in Sachse, Stage by Stage

Concrete is unforgiving. The pour is the short part. The prep underneath is what decides whether the slab is still flat and crack-free in eight years or heaving at the apron by year three. Here’s the actual sequence we run on a Sachse driveway, with the real durations.
Stage 1: Site walk and layout (1 – 2 hours)
We measure the existing approach, check the elevation at the garage threshold, and mark slopes so water runs to the street or a drainage point instead of toward the house. This is where you decide the driveway width (10 feet for one car, 16 to 20 for two), whether you want the apron flared, and where expansion joints land. Getting the slope decision right here saves a tear-out later.
Stage 2: Demolition and haul-off (1 day)
Old concrete comes up with a breaker and goes out by dumpster. A standard two-car driveway generates several tons of rubble, so this isn’t an afternoon. If a tree root has lifted a panel near the street, we expose it now so you can see the full extent before pricing the repair.
Stage 3: Subgrade prep and form setting (1 – 2 days)
This is the stage that separates a driveway from a slab that fails. On Blackland Prairie clay, we dig out to depth, proof-roll the subgrade, and bring in select fill that compacts properly, then set forms and rebar or wire mesh. You’ll see the base before the pour if you want to walk it. We schedule a city inspection here if the scope requires one.
Stage 4: The pour and finish (1 day)
Concrete arrives by truck, gets screeded to grade, floated, and finished. Standard broom finish is the default for a North Texas driveway because it grips well in rain. Exposed aggregate and stamped borders are the two other finishes homeowners pick most in Sachse. You choose the finish before the truck rolls, not during.
Stage 5: Cure and control joints (5 – 7 days before you park on it)
We cut control joints within the first day or two so the concrete cracks where we want. You stay off the surface for about a week. Driving too soon is the most common homeowner mistake and the fastest route to a spiderweb of surface cracks.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Concrete Options You’ll Actually Choose Between
Not every upgrade is worth the money, and a few are wasted on a residential driveway. Here’s the honest breakdown of what changes the look and the price.
- Standard broom finish (included baseline): The workhorse. Grippy, neat, and the cheapest finish. Best for a family that wants a clean driveway and doesn’t care about decoration.
- Exposed aggregate (adds roughly 10 – 20%): The top layer of paste is washed away to reveal the stone. Hides tire marks better than plain concrete and looks good with the brick ranch homes common in Sachse.
- Stamped border or scoring pattern: A stamped edge band dresses up the perimeter without stamping the whole slab. Cost-effective decorative upgrade.
- 4-inch vs 5-inch thickness: Four inches handles a sedan. If you park a heavy truck or an RV, we go to five or six inches with heavier rebar. Cheap insurance against cracking.
- Fiber-reinforced vs rebar: Fiber mesh helps with surface shrinkage cracks. Rebar handles structural load. For a driveway on expansive clay, rebar plus a proper base is the safer bet.
- Sealer (optional): A penetrating sealer slows moisture intrusion and helps with staining. It doesn’t fix bad prep.
If your project grows to include a patio, walkway, or paver border alongside the concrete, that wider scope lives on our Driveway & Pavers in Sachse page. Concrete alone stays here.
What Concrete Driveways & Concrete Work Costs in Sachse, TX

A full concrete driveway installation in Sachse runs $4,500 – $12,000. A replacement (tear-out plus new pour) runs $5,000 – $14,000. Those ranges are wide on purpose because the variables below swing the number hard.
- Square footage and width: A single-car driveway is a fraction of the cost of a wide two-car with a turnaround. Size is the biggest lever.
- Demolition and haul-off: Replacing existing concrete adds removal and dump fees. A clean lot doesn’t.
- Subgrade condition: Soft spots, tree roots, and failed base mean excavation and select fill. That’s real money and it’s the line item no honest bid skips.
- Finish and thickness: Exposed aggregate and heavier slabs with more steel push toward the high end.
- Permit scope and inspection: Work that touches the right-of-way or changes drainage can require a city permit and inspection, which adds time and a fee.
A written estimate should itemize demo, base prep, steel, concrete volume, finish, and disposal. What it typically leaves out: landscape repair, moving a gas line or irrigation, and engineering if the site turns up something unexpected. We flag those before the pour, not after. Estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Sachse Homes Specifically Do to This Job
Sachse is a small, mostly built-out bedroom city on the Dallas – Collin County line, and that shapes concrete work here. Most of what we do is infill and rebuild on established streets, not fresh subdivision lots. That means we’re working with mature pecan and oak canopies, tight residential streets that limit where a concrete truck can stage, and a mix of 1970s – 1990s brick ranch homes sitting right next to newer custom builds.
The bigger issue is the ground. Blackland Prairie clay swells in wet springs and shrinks through dry summers, so slab movement is routine and the driveway is where homeowners see it first: heaved panels, cracks running from the apron, a low corner holding water after every storm. On these soils, base prep and control-joint placement aren’t optional extras. It’s also why grading and drainage corrections come up so often on this work. The city’s own permitting and inspection process is the gatekeeper here, not a big metro department, so we build the schedule around it and pull permits where the scope requires. That’s also why homeowners often pair a driveway project with ADU Site Prep & Utilities in Sachse when a detached structure is going in – the grading and utility routing overlap.
We handle concrete work across Sachse and nearby Murphy, Rowlett, Garland, and Wylie. For the broader driveway picture, see our Driveway & Pavers service hub.
Serving Sachse, TX – Our Local Coverage Area
We serve Sachse and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Concrete Driveways & Concrete Work in Sachse

Most concrete driveway projects in Sachse take three to five working days from demo to pour, plus about a week before you can park on it. Weather and city inspection timing can stretch that. If you’re coordinating with other exterior work like Door Installation in Sachse, tell us up front so the schedules line up. Call (833) 954-4985 to talk through the timeline.
It depends on the scope. A replacement in the same footprint often needs no permit, while work that touches the right-of-way, changes drainage, or adds impervious cover can trigger a city review. We sort out what your specific job requires before we start. Call (833) 954-4985 and we’ll tell you what applies to your property.
Sometimes, but a pour-over only works if the existing slab is structurally sound and the height gain won’t trap water against the garage. On Sachse’s clay, a heaving slab usually means the base is the problem, and covering it just hides the failure. We test and advise honestly. Call (833) 954-4985 for an on-site look.
Expect $4,500 – $12,000 for a new driveway and $5,000 – $14,000 for a replacement, with finish, size, and base condition moving the number. You get a written line-item estimate so there are no surprise line items later. Call (833) 954-4985 for an exact quote; estimates are free.
Every project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Our technicians have up to 12 years of experience, are background-checked, and arrive in uniform. Call (833) 954-4985 to schedule your estimate.
Get a Free Concrete Estimate in Sachse
If a cracked, heaved, or too-narrow driveway is on your list this year, call (833) 954-4985 for a free on-site estimate. We’ll walk the slab, check the base and drainage, and hand you a written line-item price with no change orders waiting in the wings. Calls are answered by a live person, 24/7. Serving Sachse and the surrounding Collin and Dallas County communities.
Written by the team at Groundwork Construction Co.












