







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterPavers vs Concrete Driveway in Richardson, TX: Which One Survives the Clay?
Choose pavers if your Richardson driveway sits on expansive clay and you plan on staying in the house more than ten years. Choose concrete only if the base is engineered correctly, joints are cut properly, and you accept that a crack means replacing a whole slab. That’s the honest bottom line. Everything past this sentence explains why, and it comes down to soil, drainage, and what a failure actually costs to fix. Call (833) 954-4985 and we’ll walk your lot before you commit to either.

Why concrete cracks in Richardson and pavers don’t
Concrete is a slab. It has no give. When North Texas clay absorbs water and swells, then dries and shrinks as summer locks in, that slab is pushed and pulled from underneath until the stress finds a weak point and splits. Once it splits, the failure is permanent. You can epoxy the crack, but you can’t un-crack the section. The usual fix is tear out and repour a full section, which on a standard two-car apron runs into real money and a week of unusable driveway.
Pavers behave differently because they’re a system of small units, not one continuous pour. When the ground moves, pavers settle. They shift by a quarter inch, the sand joint takes up the movement, and the field stays intact. A settled paver walkway or driveway is a maintenance item, not a demolition project. We lift the affected units, re-level the base, and set them back. The rest of the driveway is untouched. That single difference is what flips the conventional wisdom that concrete is the durable, low-maintenance choice.
The failure mode, side by side
| What happens | Concrete | Pavers |
|---|---|---|
| Clay swells or shrinks | Slab cracks; crack is permanent | Units settle; field stays whole |
| How you fix a problem spot | Replace the full section | Lift, re-level, reset a few units |
| Hail or heavy impact | Chip or spall, hard to match | Swap a single paver |
| Years of recurring cost | Bundled into big replacement events | Spread across small spot repairs |
If you want the deeper walkthrough of how these systems get built on a Richardson lot, our Driveway & Pavers page covers base prep, edge restraint, and joint sand in detail.
Drainage on older Richardson lots makes the choice harder than it looks
Most of the original Richardson Heights plat was laid out in narrow lots with minimal grade. Water had one place to go: downhill toward the street or the drainage easement behind the block. That worked fine until infill started. When a neighbor scrapes a ranch and builds a larger two-story footprint, the impervious surface on that lot goes up, and the runoff has to go somewhere. It usually goes sideways, onto your driveway.
Concrete sheds all of that water. It sheets off the slab toward the lowest point of the lot, which on an older Richardson block is often the easement that’s already carrying more load than it was sized for. A permeable paver system with open joints and a graded aggregate base gives that water somewhere to go before it reaches the easement. We design the base and the slope together for this exact reason. It’s the difference between managing stormwater on your property and pushing it onto the neighbor’s.

What it actually costs in Richardson, and how the gap closes
Here’s the upfront reality. Pavers run $15 to $25 per square foot installed in the DFW market. Concrete runs $8 to $14. On a 600-square-foot driveway, that’s a gap you feel in the first month. The question is what the second decade looks like.
Our market-calibrated ranges for a Richardson driveway:
- Paver driveway installation: $7,000 to $18,000
- Concrete driveway installation: $4,500 to $12,000
- Driveway replacement (either material): $5,000 to $14,000
- Driveway sealing: $250 to $700
- Paver patio installation: $3,500 to $11,000
Now add one concrete replacement cycle over 20 years. On a clay-active Richardson lot, that’s realistic, not pessimistic. Fold that replacement into the lifetime math and the paver premium narrows to almost nothing, or inverts entirely when the concrete job includes hauling off the old slab and rebuilding the base underneath. Paver sealing is a cheap recurring cost by comparison, and it’s optional.
That’s the honest version. Concrete wins on day one. Pavers win on year fifteen. If you’re moving in three years, the math may favor concrete, and we’ll tell you that.
Resale and curb appeal in a redeveloping block
Drive down any street off Central Expressway where the ranch homes are being scraped and rebuilt, and you can spot the infill build from the block away. New two-story, new landscape, new hardscape. If you’re staying in your ranch and the lot two doors down just listed at a new-build price, your driveway is doing a job it wasn’t doing ten years ago. It’s signaling that your home is cared for, not patched.
A paver driveway photographs distinctly against the brick ranch backdrop. The texture reads on a listing photo in a way a concrete apron doesn’t. Concrete that’s been poured over an old pour, or shows a spiderweb of cracks, reads as a maintenance deferral. In a market where buyers are comparing your 1960s ranch against a brand-new neighbor, that impression is worth real dollars. It’s not the whole conversation, but it’s part of it.
Which material we’d actually recommend for your lot
We don’t sell one answer to every driveway. We sell the right answer for the lot. Here’s the decision framework we use on a Richardson assessment:
- Go concrete if the base is sound, you’re on a newer build with engineered fill, and you’re not planning a long hold.
- Go pavers if you’re on original 1950s-70s clay, if the lot has drainage pressure from neighboring infill, or if you want a repairable, resettable surface.
- Go pavers if curb appeal is part of your resale strategy against new construction on the same block.
- Consider permeable pavers specifically if your lot pitches into an already-stressed easement and you want the stormwater managed on-site.
Our technicians have up to 12 years of experience building on this soil, and our home page lays out the full scope of what we handle beyond the driveway. We source from a curated set of verified material partners, so you’re choosing from real product options you can see before anything is ordered, not from whatever happened to be on hand. Oldcastle and Quikrete base materials show up on our jobs regularly because they hold up to the clay. Every installation is backed by our 730-Day Done Right Promise, which means if the base settles or a unit doesn’t sit right, we come back and make it right.
Our Driveway & Pavers in Richardson page covers the local build specifics. If your project grows into something bigger, fence installation, paver patios, full driveway replacement, and sealing all tie into the same drainage and soil story. We also work just up the road in Plano and across Garland, where the lots and soils differ enough to change the plan.
Pricing works the way the rest of our projects do: upfront, no surprises. The number we quote is the number you pay. We finance at 0% for 18 months, and projects over $10,000 get $1,000 off. Calls are answered by a live person 24/7, so you’re not waiting until Monday to get a question answered.
FAQs
Pavers are usually the better long-term choice in Richardson because the expansive clay moves seasonally and pavers can settle without cracking, while concrete cracks permanently and needs full-section replacement. Concrete can be the right call on a newer lot with a sound engineered base and a short ownership horizon. The soil under your specific lot is what decides it. Call (833) 954-4985 and we’ll look at the grade and drainage before you commit.
A paver driveway in Richardson runs $7,000 to $18,000 installed, or roughly $15 to $25 per square foot in the DFW market. Concrete runs $8 to $14 per square foot, or $4,500 to $12,000 on a typical residential driveway. Factoring one concrete replacement cycle over 20 years usually closes or flips that gap. Call (833) 954-4985 for an exact quote on your square footage – estimates are free.
Not really, once a slab has cracked. You can fill a cosmetic crack, but a structural crack from clay movement means the section is compromised and the standard fix is tear out and repour. Pavers are the opposite: a settled or damaged area gets lifted, re-leveled, and reset, and the rest of the driveway stays in place. That repairability is the biggest practical difference on a clay-soil lot. Call (833) 954-4985 if you want us to look at a crack and tell you honestly which side of that line it’s on.
Yes, if it’s designed permeable. Pavers with open joints over a graded aggregate base let water infiltrate instead of sheeting it toward the street or the easement. On older platted lots where neighboring infill has increased runoff, that matters. We design the base and slope together so the water goes where it should. Call (833) 954-4985 and we’ll assess your lot’s drainage before recommending a system.
Get a no-pressure assessment
If you’d rather have it looked at before deciding, Groundwork Construction Co. of Richardson offers a no-pressure assessment in Richardson. We’ll check the base, the grade, and the drainage, then tell you which material makes sense for your lot and your timeline. Call (833) 954-4985 for a free estimate.
Written by the team at Groundwork Construction Co. of Richardson, serving Richardson, TX.


