







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Richardson: What This Job Actually Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Richardson, TX usually run $3,500 – $9,000 for new asphalt pavement and $250 – $700 for a reseal, with most full driveways laid and compacted in two to three days plus a cure window before you park on them. Resurfacing an existing asphalt base that’s still sound costs a fraction of a rebuild. Call (833) 954-4985 and we’ll give you a real number instead of a range over the phone.
How Our Asphalt Driveways & Resurfacing Process Runs, Stage by Stage

Asphalt is a schedule game. Done in the right order, it’s a clean two-to-three-day job. Done out of order, you get a driveway that cracks the first summer. Here’s how the sequence actually goes.
Stage 1: Site walk and base assessment (about 45 minutes)
We measure the footprint, check the slope away from the slab, and probe the existing base where it’s exposed. You decide right here whether we’re resurfacing over sound asphalt or tearing out to the base. That decision is the whole budget. A driveway that’s been holding water in the same low spot for a decade usually needs the base, not the top.
Stage 2: Demo and base prep (one day)
If we’re rebuilding, the old asphalt comes out and the subgrade gets graded to the run-off plan. We bring in crushed stone base at least 4 inches compacted, and deeper on the older Richardson lots where the original gravel was thin. This stage is where a driveway either lasts fifteen years or fails in three. You don’t see it when we’re done, which is why a fixed written scope matters more here than on almost any job.
Stage 3: Grading and form check (a few hours)
We set the fall – the slight pitch that invites water off the pavement and toward the street or a drain rather than back into the garage. In a Richardson house with a detached shop or oversized garage slab, that pitch has to line up with the door apron or you’ll get water at the threshold. You approve the drainage direction before we bring asphalt in.
Stage 4: Asphalt lay and compaction (a half day to a day)
Hot-mix asphalt goes down at a 2-inch compacted thickness for standard residential use, thicker if trucks or a heavy trailer will cross it. It gets rolled in lifts. Depth is something you should ask about on every bid, because a thin lift laid cold is the cheapest way to sell a driveway and the fastest way to have it rut.
Stage 5: Cure and seal decision (immediate and 6 – 12 months)
The driveway cures for several days before you drive on it, longer before heavy loads. We recommend the first seal coat around six to twelve months out, once the asphalt has cured and settled – not the same week. Your decision at this stage is whether you want the reseal on a schedule or want a reminder later. Either way, it’s a written line item.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options Richardson Homeowners Actually Choose Between
- Full-depth new asphalt (structural rebuild) – the right answer when the old pavement is crumbling, rutted, or sitting on a failed base. Highest cost per square foot, longest life.
- Overlay on a sound base – a new asphalt layer over asphalt that’s still intact. Cheaper and quicker, but only credible when the base is honest. We won’t sell this on a base that won’t hold.
- Standard 2-inch compacted lift – fine for cars, the number most homeowners want. Skip it if you’ll park an RV, trailer, or heavy truck.
- Heavier-duty lift over reinforced base – for the oversized and heavy-use drives common on Richardson properties with a detached workshop or an oversized garage. Costs more, holds up under weight.
- Reseal only – when the pavement is still structurally good and just wants a protective coat. Cheapest line item on this page, and worth doing on the right schedule.
What Asphalt Driveways & Resurfacing Costs in Richardson, TX

Plan on $3,500 – $9,000 for new asphalt paving and $5,000 – $14,000 when a full replacement is needed, with a reseal running $250 – $700. Where a job lands in that range comes down to a handful of real variables:
- Footprint size – the single biggest lever, priced per square foot.
- Existing condition – resurface over a sound base is far cheaper than a full-depth rebuild.
- Base depth and soil – an expansive clay grade that needs extra base prep pushes the number toward the top of the range.
- Heavy-use spec – thicker lift and reinforced base for trailers, RVs, or shop traffic.
- Drainage and demo – re-grading, hauling off old asphalt, and any tied-in concrete work at the apron.
A written estimate should include demo, base prep, the asphalt lift depth, compaction, and cleanup in plain numbers. What it typically won’t include: the first seal coat down the road, any concrete work at the apron or a walkway, and any drainage changes that come up after we open the base. Those are separate, and a contractor who won’t say so up front is planning a surprise later. Our pricing is fixed – the number you see is the number you pay, backed by the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Richardson Homes Specifically Do to This Job
Richardson’s building stock is two different cities under one name. The 1950s – 70s brick ranch homes – a lot of them in and around the original Richardson Heights plat near Central Expressway – were built on small lots with pier-and-beam foundations, and those drives are usually narrow, close to the house, and up against a detached garage or shop. On expansive North Texas clay, a driveway on one of these lots has often settled unevenly toward the street, and we see the same low-spot ponding on block after block. That’s where heavy use and base repair matter most, and it’s also where an oversized or heavy door on the shop drives the spring and opener decision. When a full rebuild is part of a wider project, it’s worth looking at the whole scope in our Driveway & Pavers in Richardson page – or pairing the new drive with ADU Site Prep & Utilities in Richardson if you’re adding a structure on the same lot. The city’s own redevelopment posture means demolition and re-inspection are an everyday part of the job here, and Richardson’s lot-coverage and setback rules mean even a modest addition or shop expansion gets surveyed before anyone breaks ground. We cover Richardson and the surrounding towns, and we do the homework first.
Serving Richardson, TX – Our Local Coverage Area
We serve Richardson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Richardson

Most residential jobs run two to three working days from demo to final roll, plus a cure window of several days before you park on it. Resealing is a same-day job. Schedule your free estimate and we’ll give you a firm start-to-finish window instead of an open-ended “soon.”
It depends on the scope – a straight resurface or reseal typically doesn’t, while a new drive that changes the approach, drainage, or lot coverage can. We pull the permits our work requires and pass the inspections. Call us for a free estimate and we’ll tell you exactly what your specific job needs before you commit a dollar.
Only if the base underneath is still sound – that’s the honest limit on any overlay. We assess the base first and won’t sell an overlay on a failed foundation that will have it cracking within a season. Get a free on-site estimate and we’ll show you which option your driveway actually supports.
Expect $3,500 – $9,000 for new asphalt paving, $5,000 – $14,000 for a full replacement, and $250 – $700 for a reseal. Where you land depends on footprint, base condition, and spec. Call (833) 954-4985 for a free written line-item estimate – no surprises.
Every job is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Calls are answered by a live person 24 hours a day, and our technicians arrive in uniform. Estimates are free, so start with the number and the promise in writing.
Get a Free Estimate for Asphalt Driveways & Resurfacing in Richardson
If your Richardson drive is ponding, cracking, or just past its seal cycle, we’ll come out, walk the base, and put a fixed line-item number in your hand – no guesswork, no change orders. Call (833) 954-4985 and a live person answers to schedule your free on-site estimate. On the call, we’ll confirm your address, ask about the drive’s condition and any shop or heavy-use traffic, and lock a visit time. From there, the price is in writing before we touch the pavement.
Written by the team at Groundwork Construction Co.












