







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Garland, TX: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Garland, TX typically runs $3,500 to $9,000 for a full new asphalt drive, and $5,000 to $14,000 when the job means tearing out and replacing an old surface. Most residential drives are finished in one to three days, with a cure window before you park on them. Call (833) 954-4985 for a free on-site estimate and we’ll put a written number in front of you, no obligation.
How a Garland Asphalt Drive Goes In, Stage by Stage

Resurfacing and new paving aren’t the same job, and the sequence is where the difference lives. Here’s how we run it.
Stage 1 – Walk the drive and set the scope (about 45 minutes)
We measure square footage, check the slope away from the garage, and look at what’s underneath. On Garland’s old slabs this is where we find the surprises: settled corners, tree roots pushing up near the foundation, or a base that was never compacted properly in the first place. You decide here whether we’re resurfacing over sound asphalt or tearing out and starting fresh. Saying no to a tear-out when the base is failing just means the new surface cracks in two seasons.
Stage 2 – Demo and haul-off (half a day to a full day)
If it’s a replacement, we break out the old surface and haul it away. On the postwar ranch lots around downtown Garland, that often means working around a narrow side yard and a mature oak or pecan whose roots are under the drive. We hand-dig near structural roots rather than grinding them out, because cutting a mature tree’s roots to save an hour of labor is a bad trade. You have nothing to decide here except where you want the debris staged.
Stage 3 – Base prep and grading (one day)
This is the stage nobody sees and everybody pays for later. We bring in and compact a crushed-stone base, cut the grade so water runs off the garage and not into it, and compact in lifts. A drive in Garland with blackland clay underneath needs the base to hold up through the summer swell and the winter shrink. You’ll decide on drainage details here: where the water goes, whether we tie into a swale or the street.
Stage 4 – Paving (one day)
Hot-mix asphalt goes down in layers, raked and rolled to density while it’s still workable. Thickness matters: 2 inches compacted is the residential minimum, and we go 3 inches on drives that see a heavy truck or a travel trailer. That’s a line item you’ll see on the written estimate, and it’s worth asking about on any bid you compare.
Stage 5 – Cure and sealing (3 to 12 months out)
Fresh asphalt needs to cure before it’s sealed, so we schedule the seal coat later rather than bundling it into the same week. Keep heavy vehicles off it for a few days and park in the same spots rather than on the edges. We’ll walk the finished surface with you and put the workmanship in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decisions on an asphalt drive come down to five things. Here’s the honest trade-off on each.
- New asphalt vs. resurfacing. Resurfacing (an overlay) is cheaper up front, but it only works if the base is sound and the existing surface isn’t badly cracked. On a drive that’s already alligator-cracked, an overlay buys you a couple of years at best.
- Thickness. 2 inches compacted is the floor for a residential drive. 3 inches costs more but holds up better under a heavy vehicle, a boat, or a contractor’s trailer.
- Base depth and material. A deeper compacted stone base pushes the price up but is what stops the surface from cracking when Garland clay moves underneath it.
- Edge restraint. A concrete or steel edge keeps the asphalt from spreading at the sides. Cheap bids often skip it.
- Seal coat timing. Sealing too soon traps oils in the asphalt. Sealing too late lets water in. The right window is usually the season after paving.
What Asphalt Driveways & Resurfacing Costs in Garland, TX

Expect $3,500 to $9,000 for a new asphalt drive and $5,000 to $14,000 for a full replacement. Here’s what moves the number inside that range.
- Square footage. A single-car drive in the 75041 ZIP codes is a fraction of a wide three-car apron out toward Sachse and Rowlett.
- Existing condition. A sound surface that only needs a new top layer sits at the low end. A failed base, bad grade, or root damage pushes you toward the high end, because the base has to come out.
- Base work and grading. Deep base, drainage correction, and a new edge restraint are line items, not freebies.
- Access. A narrow side yard or a drive hemmed in by mature trees slows the crew and adds labor.
- Permits and inspection. If the drive crosses a right-of-way or changes the grade toward the street, the city may want a look. We handle that paperwork when it applies.
A written estimate from us is line-item: square footage, thickness, base depth, edge, haul-off. What’s not included (like sealing, which is a separate stage) gets written down too, so nobody’s guessing later. Upfront pricing, no surprises.
See the difference
Before
After
Before
After
Before
AfterWhat Garland Homes Specifically Do to This Job
Garland built out in a handful of booms, so almost every drive we touch here is a renovation layered onto a house from the late 1940s through the 1980s, not a new build. The postwar core around downtown Garland and the 75040 corridor is where we see the most original asphalt fading into alligator cracks and settled corners, and where a mature pecan or oak is more often than not sitting within a few feet of the drive. Those trees are lovely shade and a real problem for asphalt, because their roots lift and crack the surface from underneath. The ranch sprawl east toward Rowlett and Sachse is newer but sits on the same blackland clay, which swells through the hot summers and shrinks again in wet winters. That movement is why so many Garland drives crack at the corners and settle toward the garage. If this driveway is part of a full Driveway & Pavers in Garland project, we’ll coordinate the scope so you’re not paying twice for the same base work.
Serving Garland, TX – Our Local Coverage Area
We serve Garland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Garland

A standard residential drive is demoed and paved in one to three working days, with a few more days of cure before heavy use. A large replacement with deep base work can run a full week. Call (833) 954-4985 for a timeline on your specific drive.
Often no, but it depends on whether your drive touches the public right-of-way or changes the grade toward the street. If it does, we pull the permit and make sure the inspection passes before the final surface goes down. Call us and we’ll tell you which side of that line your project falls on.
Yes, when the existing base is sound and the cracking is surface-level rather than structural. If the base is failing, an overlay is money thrown at a problem that will come back. We’ll tell you honestly which one your driveway needs. Call (833) 954-4985 for an assessment.
An overlay is cheaper than a full replacement, and sealing is cheaper still, but each only solves a specific stage of wear. A full replacement runs $5,000 to $14,000 for most Garland homes. A written line-item estimate tells you which one fits your drive, and estimates are free.
Every asphalt project we do is backed by our 730-Day Done Right Promise. If something we installed fails within that window, we make it right. Any limits on a specific surface or cure issue get spelled out in writing before work starts. Call (833) 954-4985 to talk through the details.
Homeowners planning a larger yard project often pair this with Chain Link Fence in Garland to define the property edge, or with ADU Site Prep & Utilities in Garland when a new structure means rethinking how vehicles reach the back of the lot. You can see the full scope of what we handle on our Driveway & Pavers service page, and more about how we cover the area on our Garland page.
Get a Free Asphalt Estimate in Garland
If your drive is cracked, sunken, or simply past its life, we’ll come out, walk it with you, and put a line-item number in writing. Call (833) 954-4985 for a free on-site estimate for Asphalt Driveways & Resurfacing in Garland. On the call we’ll ask a few questions about the drive’s size and condition, then set a time that works for you. A live person answers, day or night.
Written by the team at Groundwork Construction Co.












