







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Rowlett, TX: What This Job Actually Costs and How It Runs
Cabinets & countertops in Rowlett typically run $14,000 – $45,000 for a full replacement, with cabinet installation alone at $4,000 – $13,000 and countertop installation at $2,000 – $6,500. A straight cabinet and counter swap in a Dalrock-area kitchen takes two to three weeks. Call (833) 954-4985 for a free on-site estimate, and we’ll put the numbers in writing before anything gets ordered.
Rowlett sits on the east side of Lake Ray Hubbard, and the housing stock here is mostly 1990s and 2000s brick-veneer subdivision builds in ZIP codes 75088 and 75089. Those first-generation kitchens are now 25 to 30 years old. The cabinets are solid enough. The doors are loosening at the hinges, the drawer boxes are wearing through their slides, and the laminate counters are lifting at the seams. That’s the job we do most in Rowlett, and it’s a different scope than tearing out a kitchen and starting over. If your project is part of a full Kitchen Remodeling in Rowlett, we’ll tell you plainly where cabinets and counters stop and the rest of the work begins.
How the Job Runs, Stage by Stage

Cabinet and counter work is a sequencing problem. Get the order wrong and you’ll be living out of boxes for a month. Here’s the actual sequence we follow on a Rowlett kitchen.
Stage 1 – Measure and field verify (day 1, about 2 hours)
We template the existing layout, check wall plumb and floor level, and look hard at the cabinet run against the slab. In Rowlett’s clay soil, flooring and cabinet boxes are rarely square, and a replacement line that’s dead-level will show a gap at the ceiling and a reveal that wanders door to door. This visit is where we catch that. You decide at this stage whether the layout stays exactly as it is or shifts even a few inches.
Stage 2 – Demo and prep (days 2 – 3)
Out come the old doors, boxes, counters and backsplash. We cut off water at the shutoffs, cap the disposal and dishwasher lines, and haul everything away. Then we repair what demo exposed: drywall behind the old backsplash, soft subfloor near the sink, and any water-stained cabinet base. You’ll decide here if you’re keeping the existing flooring or replacing it, because cabinets and floors have to be sequenced together – in most cases cabinet boxes go down first and flooring runs to them.
Stage 3 – Cabinet install (days 4 – 6)
Base cabinets set first, shimmed level, screwed to studs and to each other. Uppers follow, hung against a verified ledger line so the crown lands flat to the ceiling. Doors and drawers get adjusted after the boxes are in, never before. This is the stage where the layout you picked either works in practice or doesn’t, and it’s where the difference between a mid-grade and premium cabinet line shows up loudest: soft-close hinges that actually self-align, drawer glides that track under a full load, and boxes that don’t flex under a heavy countertop.
Stage 4 – Template and counter fabrication (days 7 – 12)
Most counter materials are templated after cabinets are set and fabricated off-site. Quartz and granite need a physical template; butcher block and laminate can often be cut sooner. This is the longest wait in the job, and it’s why we schedule the cabinet install tight against the counter template date. You’ll confirm edge profile, sink cutout, and faucet hole spacing in this window, and we’ll hand you a sample of the slab or sample chip to approve against your lighting.
Stage 5 – Counter install, plumbing, punch list (days 13 – 15)
Counters set, seamed, and sealed. Sink and faucet get connected, disposal re-hung, dishwasher reconnected. We run water and check every joint under load. Final walkthrough covers door alignment, drawer glide tension, caulk lines, and a written punch list before we close the job. Anything that isn’t right goes on that list, and our 730-Day Done Right Promise covers it in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Weigh: Cabinets, Counters, and Where the Money Goes
Most of the decision-making happens in two rooms: the cabinet line and the counter surface. Here’s the honest trade-off of each, with the spec choices that actually come up in Rowlett kitchens.
- Stock cabinets (particleboard box, thermofoil or laminate door): the least expensive entry point, usually $4,000 – $7,000 installed in a standard kitchen. They hold up fine in a dry, low-traffic kitchen but the drawer boxes and hinges are the weak point. Best for a rental or a budget-conscious flip.
- Semi-custom cabinets (plywood box, solid wood or MDF door, soft-close hardware): the bulk of what we install. KraftMaid is a name that comes up often here – it’s the workhorse of the line. This tier is where you get the door style and finish you actually want, and it ages well past 15 years with care.
- Custom cabinets (fully built to the room, inset or full-overlay): for lakefront rebuilds and high-end kitchen jobs where the cabinet reveals have to be perfect. The cost climbs fast, but the fit in an older Rowlett home with out-of-square walls is what you’re paying for.
- Quartz: the default for most budgets. Non-porous, no annual sealing, holds a tight seam. Cambria is a strong option in this group, and the trade-off is that quartz doesn’t like a hot pan set directly on it.
- Granite: natural stone, unique slab to slab, needs sealing once a year. It’s a premium surface at a semi-premium price and it doesn’t care about heat the way quartz does.
- Butcher block and laminate: the budget picks – laminate around $2,000 – $3,500, butcher block climbing from there. Both work well in a secondary kitchen or an ADU build, and both carry honest wear that some homeowners don’t mind.
If a New Detached ADU in Rowlett is on your radar, this is the same cabinet and counter conversation in a smaller footprint, at a small-kitchen price point.
What Cabinets & Countertops Costs in Rowlett, TX

Full cabinet and counter replacement in Rowlett runs $14,000 – $45,000. Cabinet installation alone is $4,000 – $13,000, countertop installation is $2,000 – $6,500, and a kitchen island adds $3,000 – $10,000 if you’re adding one. A small kitchen or partial cabinet swap in the $9,000 – $20,000 range is common in the 75088 subdivisions.
Four things push that number up or down:
- Cabinet line and door style: stock versus semi-custom is the single biggest swing, easily a $6,000 gap on a standard run.
- Counter material: laminate to quartz moves you $2,000 – $5,000; quartz to premium granite can go higher.
- Layout changes: moving a sink, relocating the range, or shifting a wall means plumbing and electrical, and that’s where budgets break. Keeping the plumbing where it is saves real money.
- Existing condition: soft subfloor, water damage behind the sink, or an out-of-square room adds prep time before any cabinet goes in.
- Permit scope: a straight cabinet and counter replacement usually doesn’t pull a permit; moving plumbing, electrical, or a wall does. We’ll tell you which side of that line your job falls on before we commit to a number.
A written estimate from us lists cabinets, counters, demo, install, plumbing reconnect, electrical if scoped, haul-away and punch list as separate lines. What it doesn’t cover unless it’s called out: new flooring, appliance replacement, backsplash (that has its own line item – $800 – $2,500), and structural or foundation work if the walls tell us the room isn’t square.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett Homes Specifically Do to This Job
Rowlett’s late-boom housing stock sits on North Texas Blackland Prairie clay, and that clay moves. On the 75089 side especially, we regularly see slab movement that shows up as sticking cabinet doors, a gap that opens at one corner of a countertop, and brick veneer cracks on the exterior wall behind the sink. If the room is out of level, we tell you at the measure visit – not after the cabinets are in. Foundation repair is a differenttrade and a different scope, but we’ll flag it and hold the cabinet install until it’s resolved, because a $10,000 cabinet line installed over a moving slab is money thrown away.
Out along the lakefront in 75088, new custom builds and teardown-rebuilds bring a different job. Those are the inset doors, custom finishes and slab-matched counters we get called on most, and they demand far tighter tolerances than a subdivision swap. Floodplain elevation rules along the shoreline shape the framing and therefore the cabinet heights, especially on a Garage Conversion ADU in Rowlett where a wet-wall kitchenette gets built into an existing slab. Our technicians have up to 12 years of experience and they know the difference between a tract kitchen and a lakefront one.
Spring hail is the other wild card. Hail doesn’t hit cabinets, but the storm that punches a hole in a roof often brings water into the kitchen, and we’ve replaced more than a few cabinet boxes and counter sections in Waterview after a spring event. If you’re covering cabinets and counters alongside a roof or water repair, sequence the water damage first and finish the kitchen second.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Rowlett

A standard Rowlett cabinet and counter replacement takes two to three weeks from demo to punch list, with the counter template-to-install window accounting for 5 – 7 of those days. Larger jobs with layout changes can stretch to four weeks. Call (833) 954-4985 and we’ll give you a real timeline against your address.
Straight cabinet and counter replacement with no change to plumbing, electrical, or structure generally does not need a permit. Any relocation of a sink, range, or wall does, and we pull those permits and walk the inspection. We’ll tell you which side of that line your job falls on before we quote.
Yes, and it’s the most common way we do it. Keeping the sink and range where they are saves the plumbing and electrical cost that pushes a job from the low end of $14,000 toward $30,000. If you want the sink relocated for a better work triangle, we’ll price that separately so you can decide.
Add $3,000 – $10,000 to the base cabinet and counter number for an island, depending on size, cabinetry line, and whether it carries a sink or cooktop. A small island in a Dalrock-area kitchen can land near $3,000; a large cooktop island with premium counter material climbs toward the top of that range.
Our 730-Day Done Right Promise covers the workmanship on everything we install for two full years – door alignment, drawer glides, counter seams, plumbing reconnects. Manufacturer warranties on the cabinets and counters run separately and we hand you that paperwork at closeout. Call (833) 954-4985 to schedule a free estimate.
Get a Free Cabinets & Countertops Estimate in Rowlett
We’ll come out, measure the room, go over the cabinet lines and counter surfaces that fit your budget, and leave you with a written line-item estimate at no charge. If foundation or water damage turns up, we’ll tell you before you commit to a cabinet order. Call (833) 954-4985 to book it. Live person, 24/7. You’ll also see $1,000 off projects over $10,000 and 0% financing for 18 months on approved credit. For the broader project scope across Rowlett, our Kitchen Remodeling service covers the rest.
Written by the team at Groundwork Construction Co.












