







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Garland: What the Job Really Involves
Cabinets & countertops in Garland typically run $14,000 – $45,000 for a full tear-out and replacement, and most single-kitchen jobs are finished in two to three weeks once materials land. The work is mostly demolition, layout, cabinet setting, templating, and stone install layered onto houses that were framed decades ago. Call (833) 954-4985 to schedule a free estimate and get a written number before anything gets ordered.
How we run a cabinet and countertop job, stage by stage

Every job follows the same sequence, and knowing it in advance is the difference between a smooth install and a kitchen that sits half-finished for a month. Here’s what actually happens.
Stage 1: Measure, verify, and order (week one)
We measure the room, check every wall for plumb and the floor for level, and confirm where the existing plumbing and electrical land behind the old cabinets. On Garland slab-on-grade houses this is where surprises turn up: a wall that’s bowed a half inch, or a drain stub that isn’t where the last remodeler said it was. Cabinet lead time usually runs 4 to 8 weeks depending on the line, so this stage sets the whole schedule. You decide door style, finish, and box construction here, not later.
Stage 2: Demo and prep (days one and two)
We pull the old cabinets and countertops, cap the plumbing, and protect the floor. This is also when we find out whether the wall behind the old backsplash needs patching or new substrate. If the layout is changing, the plumber and electrician move their rough-ins now, before anything new goes in. Skipping that order is the single most common reason a Garland cabinet job stalls.
Stage 3: Cabinet setting (days three through five)
Base and wall cabinets get set, shimmed, and screwed to studs, not just to each other. We level across the whole run because stone sits on top of it, and a wavy cabinet line means a wavy countertop. You confirm hardware placement and drawer configuration before we drill anything.
Stage 4: Template and stone install (days six through ten)
For quartz or granite, a templater comes out after the cabinets are set, then the slab is cut and installed a few days later. Laminate or butcher block can go in the same week. Sink cutouts and faucet holes get confirmed at template, and this is the last easy moment to change your mind about the sink.
Stage 5: Final trim and punch list (days eleven through fourteen)
Toe kick, filler panels, and any window or door casing go on last. We walk the kitchen with you, check door reveal and drawer glide, and close out the punch list in writing. Anything we touched is covered by the 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between in Garland
Most of the budget conversation comes down to four decisions. Here’s the honest version of each.
- Stock, semi-custom, or custom cabinets. Stock boxes are the cheapest and fastest but come in fixed sizes that leave gaps; semi-custom is the sweet spot for most Garland ranches, and custom is worth it only when the room has odd angles or you’re chasing a specific look. KraftMaid sits comfortably in the semi-custom range and holds up well in a busy kitchen.
- Quartz versus granite versus laminate. Quartz needs no sealing and takes abuse, granite handles heat better but needs resealing every year or so, and laminate is the budget play at a fraction of the cost with a shorter lifespan. Cambria quartz is a solid middle path for homeowners who want a consistent pattern.
- Box construction and drawer hardware. Plywood boxes outlast particleboard in a humid Texas kitchen, and soft-close, full-extension glides are worth the upcharge on the drawers you actually use every day.
- Layout changes. Keeping the sink and range where they are saves real money. Moving either one means new rough-in plumbing and electrical, which is where a modest job climbs toward the top of the range.
What Cabinets & Countertops costs in Garland, TX

Cabinet installation in Garland runs $4,000 – $13,000, countertop installation runs $2,000 – $6,500, and a kitchen island adds $3,000 – $10,000 if you’re putting one in. Put those together with demo and finish work and a full cabinet and countertop package lands in the $14,000 – $45,000 band. Here’s what moves a job toward each end:
- Kitchen size and cabinet count. A tight galley near downtown Garland sits near the low end; a long ranch kitchen with a peninsula and island pushes toward the high end.
- Existing condition. Cracked plaster, water damage behind the old sink, or a floor that isn’t level adds prep work that has to happen before anything new goes in.
- Moving plumbing or electrical. Relocating the sink, range, or dishwasher means licensed trades and often a permit, and that’s a real line item.
- Material grade. Laminate and stock cabinets versus quartz and semi-custom is most of the spread between the low and high numbers.
- Permit scope. Straight swap-outs usually don’t need one; moving gas, water, or walls does.
Your written estimate itemizes cabinets, stone, labor, demo, and any trade work, so there are no surprises once the job starts. What’s usually excluded is appliance cost, and sometimes backsplash tile if you’re sourcing it yourself.
See the difference
Before
After
Before
After
Before
AfterWhat Garland homes specifically do to this job
Garland grew up in a handful of postwar booms, and almost every kitchen job here is a renovation layered onto a mid-century slab-on-grade house rather than a new build. That matters for cabinets and countertops in a few concrete ways. The 1950s and 60s stock near downtown often has walls that are out of plumb and floors that have settled, so setting a level cabinet run takes more shimming than it would in newer construction. North Texas blackland clay expands and contracts through hot summers and wet winters, and that slab movement shows up as cracks and uneven floors we have to account for during prep. The older sections along the 75040 and 75041 corridor also have mature pecan and oak canopies close to the house, which means less light and more debris in the work area, so site protection runs a little heavier. Toward the 1970s and 80s ranch sprawl out by Rowlett and Sachse, kitchens tend to be larger and more open, which usually means more cabinet boxes and a bigger countertop run. If the job turns into a wider remodel, that’s where our Kitchen Remodeling in Garland work picks up.
Serving Garland, TX – Our Local Coverage Area
We serve Garland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Cabinets & Countertops in Garland

Plan on two to three weeks of on-site work, plus 4 to 8 weeks of cabinet lead time before demolition starts. Quartz and granite add a few days for templating and fabrication. Call (833) 954-4985 for a schedule built around your actual cabinet line.
A straight cabinet and countertop swap usually doesn’t require a permit, but moving plumbing, gas, or electrical does. We tell you upfront whether your job crosses that line, and we pull permits and pass inspections when it’s needed. Estimates are free.
Yes, and that’s the cheaper path. Keeping the sink, range, and dishwasher where they sit avoids new rough-ins and keeps the job inside the lower end of the range. If you want a new layout, we scope the trade work before you commit.
Cabinet installation runs $4,000 – $13,000, countertops run $2,000 – $6,500, and a full package lands at $14,000 – $45,000. Material grade, kitchen size, and layout changes drive most of the spread. Call (833) 954-4985 for an exact written quote.
Every cabinet and countertop install is covered by the 730-Day Done Right Promise, and if it’s not done right we come back and make it right. Our technicians are background-checked and arrive in uniform, and calls reach a live person 24/7.
Get a free estimate on cabinets and countertops in Garland
We’ll come out, measure the kitchen, check what’s behind the old cabinets, and hand you a written line-item estimate covering cabinets, stone, labor, and any trade work, with no change orders and 0% financing for 18 months available. Call (833) 954-4985 to schedule your free estimate. If you’re planning a bigger project, homeowners often pair this with a Garage Conversion ADU in Garland or a New Detached ADU in Garland, and we cover the whole Garland area through our Kitchen Remodeling service.
Written by the team at Groundwork Construction Co.












