







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Wylie, TX: What It Costs and How Long It Takes
A chain link fence in Wylie, TX usually runs $3,500 to $9,000 for a standard residential yard, and most jobs are finished in one to two days once materials are on site. The variables that move that number are linear footage, height, gate count, and whether the run crosses the expansive Blackland Prairie clay that gives Wylie fences their footing problems. For an exact figure on your lot, call (833) 954-4985, and we’ll walk the property and write a line-item estimate. Estimates are free.
How a Chain Link Fence Goes In, Start to Finish

Every job follows the same five stages. What changes is the ground under it and how many gates you’re cutting in.
Stage 1: Site walk and layout (day 1, about an hour). We mark the fence line with you, confirm property corners against your survey, and flag anything buried. This is the stage where you decide height (4, 5, or 6 feet) and gate placement. Utility locates get called before ground is broken. Expect a two-to-three-day wait on those before digging starts.
Stage 2: Digging and setting posts (day 1 and into day 2). We drill or auger holes at the spacing the manufacturer specs call for, typically 8 to 10 feet on center. Corner, end, and gate posts get set in concrete and often go deeper than line posts. On Wylie’s shrinking clay, hole depth and concrete volume matter more than they do on stable soil. Posts cure overnight.
Stage 3: Terminals, rails, and tension (day 2). Top rail, tension bands, and brace bands go on the posts that carry the load. You’ll see the frame come together in a couple of hours on a normal residential run.
Stage 4: Fabric and gates hang (day 2). The mesh gets stretched and tied off, then gates get hung, squared, and checked for swing. A double gate for a trailer or RV pad takes longer than a walk gate.
Stage 5: Walkthrough and clean-up (same day). We walk the line with you, check tension and gate latches, haul off scrap, and backfill. That’s the handoff. Any punch-list item gets scheduled before we leave.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Fence Options: Height, Gauge, and Coating
What you pick here decides what the fence does ten years out. Here’s the honest trade-off on each.
- Height. 4-foot is the budget choice and won’t keep a determined dog in. 5-foot is the residential sweet spot. 6-foot is what you want for a pool, a shop yard, or anything you don’t want seen. Each step up adds linear footage of fabric and taller posts, so it costs more, but not proportionally.
- Wire gauge. 11.5-gauge is the standard residential fabric. 9-gauge is heavier and resists denting and sagging far better, and it’s what we’d put around a workshop or on a run that backs up to open field where wind loads hit. The heavier fabric runs more per foot, but it’s the cheaper fence over its life.
- Coating. Galvanized is plain steel and shows rust first along the bottom rail. Vinyl-coated (green or black) hides the rust and blends into the tree line, which is why most Wylie acreage owners ask for it. Coating adds cost and it will eventually chip at a cut end, but it’s the better call where appearance matters.
- Post and rail. Standard 1 5/8-inch line posts suit most yards. Heavier pipe for corners, gates, and long runs in soft clay. Don’t skip this; cheap posts are what we get called to fix.
- Brands and fittings. Master Halco and Ameristar make the pipe and fabric we work with most, and both hold up to North Texas sun and hail cycles. We spec American-made fittings on gates because imported hinges wear out first.
- Gates and access. Walk gates, double drive gates, and sliding or cantilever gates for a shop yard or equipment pad. Each gate is a decision point on width and hinge side. Wide double gates need heavier posts; plan for it at Stage 1, not after the concrete sets.
What a Chain Link Fence Costs in Wylie, TX

The real range is $3,500 to $9,000 for a typical Wylie residential job. Five variables push a job from the low end to the high end:
- Linear footage. A small downtown-lot yard at 100 feet sits near $3,500. A half-acre run at 400 feet climbs toward $9,000.
- Height and gauge. A 6-foot 9-gauge run costs meaningfully more than a 4-foot 11.5-gauge run of the same length.
- Gates. Each gate adds hardware and heavier posts. A double drive gate costs more than a walk gate.
- Ground conditions. Expansive clay, caliche, roots, or a run through a drainage swale means deeper holes, more concrete, and sometimes a post that has to be set differently. That’s labor, and it’s in the quote.
- Removal of an old fence. Tear-out and haul-off is priced separately from new install. Budget for it if there’s an existing line.
Your written estimate lists linear footage, post spacing and depth, gauge and coating, gate schedule, concrete, and haul-off. What it won’t include unless we quote it: utility relocation, grading, or fence line changes after layout is approved. Upfront pricing is the rule. The number you see is the number you pay, backed in writing by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Wylie Lots Do to a Chain Link Fence
Wylie’s ground is the story here. Much of the newer development east and south sits on former Blackland Prairie farmland, and that soil is expansive clay that swells when wet and shrinks in drought. Posts set in shallow holes work loose and lean within a season or two. That’s why we set deeper and use more concrete here than we would on stable ground, and it’s why a post that looked plumb in June can be off by an inch in August. On the older ranch homes near the Ballard Avenue historic district downtown, we’re more often pulling out a tired galvanized line that’s rusted through at the bottom rail after decades in the sun. Along the 75098 corridor, spring hail and wind events are the other factor. A 6-foot chain link catches a lot of wind, and gates are the first thing to go out of square. That’s the reason we spec heavier gate posts and check latches on the walkthrough. Whether you’re fencing a new build or replacing a line on a 1970s lot, the run needs to be laid out with that clay in mind, not just measured in feet. This is part of a full Fence Installation in Wylie scope if you’re fencing the whole property at once.
Serving Wylie, TX – Our Local Coverage Area
We serve Wylie and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Wylie

Most residential installations take one to two days on site, with a few days of lead time for utilities and materials. The utility locate wait is the step homeowners don’t plan for, so book a week out if you can. Call (833) 954-4985 to get a firm timeline for your lot.
Wylie generally does not require a permit for a standard residential chain link fence, though height limits and setback rules apply, and HOA rules in newer subdivisions nearly always require written approval before install. We check the rule that applies to your lot before we dig, so there’s no surprise after the fact. Call (833) 954-4985 and we’ll confirm what applies to your address.
No, the number on your written estimate is the number you pay unless you ask for a change. The estimate is line-item, so you can see exactly what footage, gauge, and gates you’re paying for. If we hit rock we didn’t see on the walk, we stop and talk to you before we change anything. Call (833) 954-4985 for your free on-site estimate.
Yes, in most cases. Chain link is post-and-mesh, so there’s no trench and no concrete slab to pour, and the disturbed ground is limited to the post holes. Buried irrigation and utilities do get located first, and if a line runs the fence path we reroute the fence, not the line. Call (833) 954-4985 and we’ll scope it on site.
Every chain link job we install is covered by our 730-Day Done Right Promise. If a post leans, a gate sags, or the work isn’t right, we come back and make it right. That’s one of the longest workmanship guarantees in the residential construction space. Call (833) 954-4985 for the details.
Get Your Free Chain Link Fence Estimate in Wylie
Call (833) 954-4985 and a live person picks up any hour of any day. We’ll set a time to walk your property in Wylie, measure the run, check the ground and any buried lines, and hand you a written line-item estimate with no pressure and no surprise add-ons. If you’re fencing a shop yard or equipment pad, homeowners often pair this with ADU Site Prep & Utilities in Wylie while the ground is open.
Looking at the wider property? Our Fence Installation service covers the full scope, and you can see everything we do across Wylie and how it fits together. Many Wylie homeowners also ask about Door Installation in Wylie for outbuildings and shop entries. And if a heavier-duty gate system is in the plan, we’ll spec it at the same visit.
Written by the team at Groundwork Construction Co.












