







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in McKinney, TX: What the Job Actually Involves
Paver driveways in McKinney typically run $7,000 – $18,000, with most residential installs landing in the $9,000 – $13,000 range for a two-car apron and turnaround. The work takes 4 – 7 working days: one to demo and haul off the old surface, one to two for excavation and base, two to three for setting pavers and cutting edges, and a final day for polymeric sand and cleanup. Call (833) 954-4985 and we’ll walk your driveway, check your soil and slope, and put a written, line-item number in your hands.
How We Build a Paver Driveway, Stage by Stage

People assume pavers mean “drop them on the ground and tamp.” The base is 70% of the job, and everything you’re paying for lives under the surface you’ll see.
Day 1: Demo and haul-off
We break out and remove the existing concrete, asphalt or gravel, then load and haul it off-site. On a 75070 or 75071 lot this is usually a clean concrete slab, which is straightforward. Downtown in the 75069 core it can mean old cobble, multiple pours over decades, or a slab poured tight to a pier-and-beam house. You decide at this point whether any of the old surface stays as a base layer (rare) or goes entirely (standard).
Days 1 – 2: Excavation and base prep
We excavate 7 – 9 inches, then build a compacted crushed-stone base in lifts, wetting and plate-compacting each one. This is the stage that fights McKinney‘s expansive clay. On clay that swells and shrinks with wet-dry cycles, a shallow base cracks and heaves within a couple of seasons. We also set final grade and slope here so water runs off the driveway, not into your foundation. You approve the slope and drainage direction before we move on.
Days 2 – 3: Edge restraint and bedding sand
Edge restraints get pinned along both sides and set in concrete. This is the piece most homeowners never think about and most failing driveways are missing. Without restraint the field creeps downhill and opens joints. Then a screeded layer of bedding sand goes down, ready for pavers.
Days 3 – 5: Setting pavers and cutting
Pavers go down in your chosen pattern, then we make all the cuts around your driveway apron, sidewalk, garage slab and utilities. You’ll want to decide two things here and only here: the pattern (running bond, herringbone, basketweave) and the color blend. Herringbone costs a bit more in labor and cutting but locks together and resists creep in clay. Delivery and material lead time on the pattern you pick can add a week before the crew even starts, so lock that in early.
Day 5 – 7: Polymeric sand, compaction, final walk
We sweep polymeric sand into the joints, activate it with water, then a final pass with a plate compactor. Then we walk the finished driveway with you, joint by joint. Expect the sand to settle and need a top-off after the first full season.
Total floor: 4 full working days, up to 7 with a tricky cut job or weather. We don’t call a driveway finished until that walk is done.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
You’re picking a material, a size, a pattern and a color blend, and each choice moves both the price and how the driveway lives. Here’s the honest trade-off set for a McKinney job.
- Concrete pavers (the standard choice): Interlocking, high-compressive-strength units that handle clay movement best because the joints flex. 60mm is the common residential thickness; 80mm is worth it for a heavy truck or RV pad. Higher upfront cost than asphalt, and they last far longer with a plain sand joint.
- Clay brick pavers: Warmer look, classic fit for a historic 75069 home, and excellent color permanence in Texas sun. Costlier, more labor to lay, and can chip under heavy point loads. Choose them for the look you want and accept a higher install line.
- Size and shape: Standard 4×8-ish units are the budget baseline. Oversized, tumbled or specialty shapes cost more per square foot and more in cutting time. You get a slightly cleaner field and a steeper bill.
- Pattern: Running bond is the least labor. Herringbone and basketweave add labor but grip and hold together better under clay movement and turning tires.
- Finish: Standard is fine. A penetrating sealer ($250 – $700 as a separate step) helps with stain, color and joint sand retention but is not a fix for a bad base, and we’ll say so out loud.
If this job is part of a Driveway & Pavers in McKinney plan that also touches a walkway, you can match material, color and pattern across the whole run so the property reads as one design rather than two separate projects. Our Driveway & Pavers service covers that wider scope when you need it.
What Paver Driveways Cost in McKinney, TX

A full paver driveway in McKinney runs $7,000 – $18,000. The low end is a modest two-car apron with a standard unit and simple pattern on a clean slab. The high end is a long driveway, tight grades, a heavy-use pad, or a specialty unit and a complex pattern.
What moves the number, in order of weight:
- Square footage: The single biggest driver. A double-wide driveway at 600 sq ft sits far below a long 1,200 sq ft run to a detached shop or garage.
- Existing surface and demo: A clean single slab is quick. Multiple pours, old cobble or a tight historic-core demo add labor.
- Base depth and soil: Clay-heavy lots with grade changes need more excavation, more stone and possibly more edge work. We price this from a site walk, not a phone guess.
- Material grade: Clay brick, oversized or tumbled units and specialty blends sit higher than standard concrete pavers.
- Pattern and cuts: Herringbone, basketweave and heavy utility cutting raise labor. So does anything requiring custom edge fitting at the apron.
A written estimate should itemize demo, haul-off, base material, pavers, edge restraint, sand, compaction and cleanup, with no line that says “miscellaneous.” What it typically excludes is the underlying slab or foundation correction if we uncover a real structural issue, and any separate drainage or sod repair. We price upfront, and the number you see on the estimate is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat McKinney Homes Do to This Job Specifically
McKinney throws two very different jobs at a paver driveway crew. Out in the newer 75070 and 75071 subdivisions, you’re working on post-tension slabs on expansive clay, and the driveway often needs correcting at the slab itself before pavers make sense. We’ve pulled out plenty of settling and shifting slabs on homes built in the 2005 – 2015 window. Meanwhile, in the historic 75069 core around the downtown square, exterior changes to a contributing structure are reviewed by the Historic Preservation Advisory Board, and that approval timeline can add weeks a typical subdivision job never sees. We plan that review into your schedule rather than around it. The real failure pattern we repair here is a paver job laid over an unaddressed clay problem: joints open, the field creeps downhill, and the driveway looks wrong within two summers. That’s why we don’t skip the base. When a driveway job is part of a McKinney whole-property plan, one crew and one scope keeps every stage coordinated.
Serving McKinney, TX – Our Local Coverage Area
We serve McKinney and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in McKinney

Most McKinney paver driveways take 4 – 7 working days on the ground, split into demo, base prep, laying and finishing. A downtown 75069 project can add a week or more at the front for Historic Preservation Advisory Board review, and a specialty paver order adds lead time before the crew starts. Call (833) 954-4985 and we’ll give you a real calendar window, not a range that means nothing.
It depends on what you’re changing. A like-for-like driveway replacement on an existing apron often doesn’t need a full permit, while moving or widening the apron to the street, cutting a new curb, or any work in the historic core typically triggers review and possibly a permit. We confirm the requirement for your address and pull what’s needed before we start. Call us and we’ll tell you straight for your lot.
In most cases yes, but the base excavation depth is the deciding factor. We excavate to get 7 – 9 inches of compacted base, which stays above standard slab top for a normal grade. If our site walk uncovers a slab or foundation problem, we stop and price the correction separately rather than burying it under pavers. That walk and those answers come free.
Expect $7,000 – $18,000, with most standard residential installs in the $9,000 – $13,000 range. Size, existing surface, clay and base depth, material grade and pattern are what push a job toward either end. Call (833) 954-4985 for a written, line-item number, and estimates are free.
Every paver driveway we build is covered by our 730-Day Done Right Promise. If it’s not done right, we make it right, in writing, for two full years. Material warranty comes from the paver manufacturer and runs longer, and we hand you that documentation with the final walk.
Get a Free Paver Driveway Estimate in McKinney
Call (833) 954-4985 for a free on-site estimate on paver driveways in McKinney. We walk the driveway with you, check the base and slope, talk through your material and pattern options, and put a written, line-item price in your hands, no change-order games. A live person answers, and the estimate costs you nothing.
Written by the team at Groundwork Construction Co.












