







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Richardson, TX: Cost, Timeline and What’s Under the Base
Paver driveways in Richardson typically run $7,000 to $18,000 for a standard two-car apron, and a full installation takes five to nine working days from demolition to the last sweep of polymeric sand. The number moves with square footage, base depth, and how much of the old surface has to come out first. Call (833) 954-4985 and we’ll walk your lot, measure the existing drive, and give you a written line-item price before a single paver is ordered.
How Paver Driveways Get Built Here, Stage by Stage

Every job starts with a layout decision you make on day one, not a truck arriving with a guess. We mark the edge lines, confirm the slope away from the garage, and check where the downspouts and any buried irrigation lines run. On Richardson’s older blocks the existing driveway often sits a few inches proud of the yard, and correcting that grade is the first real cost driver.
Stage 1: Demolition and haul-off. The old concrete or asphalt comes out with a mini-excavator and the spoil is hauled the same day. On a typical 400 to 600 square foot drive, that’s one full day. You decide here whether the apron stays the same footprint or widens toward the street; widening means checking setback before we cut.
Stage 2: Excavation and subgrade prep. We dig down far enough to hold six to eight inches of compacted base below the paver thickness, then proof-roll the subgrade to find soft spots. On expansive clay, a soft pocket means excavation and replacement with select fill, which can add half a day. This is the part nobody sees and the only part that decides whether the drive stays flat in five years.
Stage 3: Base and compaction. Flex-base or crushed stone goes in two lifts, each compacted with a plate and watered to grade. This is a full day of work on most drives, and we measure slope with a level every few feet. Get this wrong and the pavers telegraph every imperfection within two summers of Texas heat.
Stage 4: Setting bed and paver install. A one-inch sand or fine-chip setting bed goes down, then the pavers lay in the chosen pattern. A two-person crew sets roughly 300 to 500 square feet a day. You’ll confirm the pattern, border treatment, and whether a soldier course runs the perimeter before the first pallet is opened.
Stage 5: Edge restraint, sand, and cleanup. We install edge restraint anchored into the base, sweep polymeric sand into the joints, mist it to activate the binder, and clean the finished surface. Figure half a day. We walk the finished drive with you and show you the joint lines and drainage slope.
Weather in North Texas sets the calendar here more than anything else. Summer heat means starting early and working in the cool hours; winter ice means waiting for a dry subgrade before base work, because compacting wet clay is a shortcut to a wavy drive.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You’ll Actually Choose Between
The material decision is the one you live with longest, so it’s worth walking a few sample boards before you commit. Here’s what changes the number and the result:
- Concrete vs. clay pavers. Concrete pavers (the workhorse choice) run $7,000 to $14,000 for a standard drive and suit most Richardson ranch-home frontages. Clay pavers push $12,000 to $18,000, hold their color better under UV, and finish a little more formal. Brands like Belgard, one of our curated material partners, sit in the concrete paver tier most of our Richardson clients choose.
- Paver thickness. 60mm is the standard residential spec. 80mm costs more and earns it on driveways where heavy trucks or a boat trailer roll over the apron. Thin 40mm pavers belong on a patio, not a driveway, and we won’t set them here.
- Pattern. Running bond is the fastest and least expensive to lay. Herringbone and basketweave take longer, cost a little more in labor, and handle turning wheels better. A border course in a contrasting color adds a fraction of the total and frames the drive nicely.
- Finish and color. A smooth tumbled finish shows tire tracks less than a highly polished face. Lighter tones run cooler underfoot in July and August. Tumbled or antiqued edges hide minor chips in a way that sharp-cut edges don’t.
- Permeable vs. standard joint. Standard polymeric sand joints are the default. Permeable open-graded joints cost a little more but push runoff through the surface instead of down the street, which matters on lots near Central Expressway that already handle a lot of water.
Edging material, drainage stone under the base, and a small curb at the street are all worth deciding up front rather than mid-job.
What Paver Driveways Cost in Richardson, TX

A standard two-car paver driveway in Richardson lands between $7,000 and $18,000. Here’s how the job breaks out in a line-item estimate, with the ranges we see most often:
- Demolition and haul-off of the existing surface: $600 to $1,400
- Excavation and subgrade prep: $1,200 to $2,800
- Base material and compaction: $1,000 to $2,200
- Pavers and setting materials (400 to 600 sq ft): $3,500 to $8,000
- Labor and install: $1,800 to $3,600
- Edge restraint and polymeric sand: $400 to $800
Five things push a job toward the top of that range: square footage, how bad the existing concrete or asphalt is (a thin overlay comes out faster than a foot of reinforced slab), whether a soft subgrade needs over-excavation, the paver grade and brand you choose, and whether the new drive footprint needs a curb cut or a setback variance. All of those get priced in writing before we start. Upfront pricing, no surprises: the number you sign is the number you pay.
What’s in our written estimate: demolition, haul-off, base material, compaction, paver supply, edge restraint, polymeric sand, and cleanup. What we quote separately if you need it: irrigation rerouting, drainage correction, a new apron at the street, or a subtle re-grade of the yard where the drive meets the lawn. Those aren’t surprises later or padding now; they’re separate lines you can approve or skip.
See the difference
Before
After
Before
After
Before
AfterWhat Richardson Homes Specifically Do to This Job
Richardson’s core is 1950s to 1970s single-story brick ranch homes, many on pier-and-beam foundations, and that changes a driveway job in ways you don’t see in a newer suburb. Original drives on the older blocks often sit above a subgrade that’s been pounded by decades of expansive clay movement. We see alligator cracking where the original slab has locked into the soil, low spots that hold water against the garage threshold, and drain-age that sends runoff toward the foundation instead of away from it. On our plaza-tree blocks the tree roots also find their way under original concrete. When the driveway is part of a full Driveway & Pavers in Richardson project, we plan the base and the drainage together with the rest of the hardscape. Richardson’s own aggressive infill and redevelopment posture means permits and demolition inspection are an everyday part of the job here. If you’re widening a drive on one of the narrow original lots near Central Expressway, confirm setback before we cut. The neighbor’s new build got built because someone did the survey homework first. If your project also touches the front entrance, homeowners often pair a paver drive with Door Installation in Richardson while the crew is already on site, and inside the house you’ll find Cabinets & Countertops in Richardson scheduled as a separate job. We cover all of Richardson, from the older platted blocks to the newer builds, and we’ll tell you straight which one we’re standing on. For the full range of hardscape we handle, see our Driveway & Pavers service.
Serving Richardson, TX – Our Local Coverage Area
We serve Richardson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Richardson

A standard two-car paver driveway in Richardson takes five to nine working days from demolition to the final sweep. Small drives (under 400 square feet) can finish in under a week; larger jobs with soft subgrade or drainage work push toward the top of that range. Weather adds time in the winter when the subgrade won’t dry, and your written schedule will list the start and finish dates the crew holds to. Call (833) 954-4985 and we’ll confirm a start window on the walk-through.
Most standard paver driveway replacements in Richardson do not require a building permit if the footprint stays the same. You do need a permit or approval when you widen the apron, change the curb cut at the street, or cross a setback line, and HOA rules can add a separate approval on top of the city’s. We pull the permits and pass the inspections on any scope that triggers them, and we’ll tell you up front whether your job needs one. Call (833) 954-4985 for a free estimate and a permit answer specific to your lot.
Usually, yes. Most driveway jobs in Richardson go in without touching plumbing or gas lines because those run below the subgrade depth we work in. We identify buried utilities, irrigation runs, and sprinkler heads during the walk-through, then set base depth around them. When something has to move (a head, a valve box, a downspout tie-in), it shows up as a separate line in the written estimate so you can see what it costs before we start. Call (833) 954-4985 and we’ll flag utility conflicts on the free walk-through.
Paver driveways in Richardson cost $7,000 to $18,000 for a typical two-car drive, and the price you sign is the price you pay. Our written estimate is line-item, so base prep, pavers, labor, and sand are priced separately and the total doesn’t move because the crew got stuck in the clay or the pallet came in late. Any change you request is priced in writing and approved before we cut. Call (833) 954-4985 to schedule a free on-site estimate.
Every paver driveway we install in Richardson is covered by our 730-Day Done Right Promise: if the base settles, a joint opens, or the edge restraint gives, we come back and make it right for two full years after we finish. The paver manufacturer warranty runs longer and covers the product itself; combine that with the install warranty and you have a written record from both the manufacturer and the installer. If it’s not done right, we make it right. Call (833) 954-4985 to get your estimate started.
Get a Free Paver Driveway Estimate in Richardson
Call (833) 954-4985 to schedule a free on-site estimate for paver driveways in Richardson. We’ll walk the lot, measure the existing drive, check slope and drainage, and hand you a written line-item price with the 730-Day Done Right Promise behind it. Calls are answered by a live person, and estimates are free.
Written by the team at Groundwork Construction Co.












